PocketAthletePocketAthleteJoin the waitlist

Weightlifting · Position guide

How a olympic lifting should train

Explosive strength-speed — clean, jerk and snatch with precision.

The short answer

A olympic lifting should build rate of force development and mobility for positions, and practise clean & jerk technique and snatch technique. The drills that matter most are tempo squats, setup and wedge, overhead holds. 5 of them need nobody but you.

⚡ Prioritise physically

  • Rate of force development
  • Mobility for positions
  • Max strength base

🎯 Sharpen technically

  • Clean & jerk technique
  • Snatch technique
  • Positional mobility

Key exercises

Power clean

Trains rate of force development — raw explosive power.

Front squat

Builds quad strength and a strong, upright trunk position.

Overhead press

Builds pressing power and shoulder stability.

Barbell back squat

The foundational lower-body strength lift — carries over to every sport.

Technical drills for a olympic lifting

5 of these need nobody but you.

Tempo squats

Squat techniqueOn your own

Setup: An empty bar or about 50% of your working weight.

  1. 1. Five seconds down, two seconds paused at the bottom, then stand normally.
  2. 2. Keep the bar over mid-foot the whole way — film from the side to check.
  3. 3. Brace before you unrack, not on the way down.

Volume: 4 × 3

Coaching point: The pause removes the bounce. Whatever position you're in at the bottom is the position you actually own.

Make it harder: Add weight only once all reps hold position, then shorten the pause.

Setup and wedge

Deadlift techniqueOn your own

Setup: A loaded bar at about 60%.

  1. 1. Take your stance, grip, then pull your chest up to take the slack out of the bar.
  2. 2. Hold that wedged position for two seconds before the bar leaves the floor.
  3. 3. Lift, then reset completely — no touch-and-go.

Volume: 6 × 2

Coaching point: Hear the bar click into the plates before you pull. Yanking a loose bar is how backs get hurt.

Make it harder: Add weight once the setup is identical on every rep.

Overhead holds

Overhead positionOn your own

Setup: An empty bar or a broomstick.

  1. 1. Press or snatch the bar overhead with a wide grip.
  2. 2. Lock the elbows, push the head slightly through, ribs down.
  3. 3. Hold, then walk ten steps without letting the bar drift forward.

Volume: 5 × 20 seconds

Coaching point: If the bar sits in front of your ears you're holding it with your shoulders instead of your skeleton.

Make it harder: Add a light load, or hold in a quarter squat.

Halting clean pull

Pull techniqueOn your own

Setup: A bar at roughly 70% of your clean.

  1. 1. Pull to just above the knee and stop dead, shoulders still over the bar.
  2. 2. Hold for two seconds, feeling the weight in the middle of the foot.
  3. 3. Finish the pull with a hard hip extension, or lower and reset.

Volume: 5 × 3

Coaching point: Shoulders in front of the bar at the knee. Let them drift back and the bar swings away from you.

Make it harder: Raise the halt position, or take the pause out and go straight through.

Breathe and brace practice

BracingOn your own

Setup: Nothing, or a light belt.

  1. 1. Breathe into your stomach and sides, not your chest.
  2. 2. Brace as if about to take a punch, without letting the air out.
  3. 3. Hold the brace for ten seconds, then breathe out and repeat.

Volume: 3 × 5 breaths

Coaching point: Pressure goes 360° around the trunk. Sucking the stomach in is the opposite of a brace.

Make it harder: Practise it under a light bar, then at your working weight.

Get a program built around you

PocketAthlete builds your program from your sport, your position and how recovered you actually are that morning — then adapts it as you log sessions.

Join the waitlist →